Dodge 9.25" 12 Bolt Rear End Girdle

Made from 356-T6 cast aluminum, these girdles incorporate a reinforced crossbar. The crossbar houses the load bolts that apply pressure to the bearing caps. This feature, along with the thick casting, prevents bearing cap deflection under severe loads, which in turn greatly reduces or eliminates (in most cases) bearing cap fatigue and failure.

With over 20 years experience manufacturing these rear end girdles, this is the most widely used and respected girdle in the industry.  This girdle is the ONLY girdle that has been thoroughly tested and approved by an automotive manufacturer. There are many copies of this cover available on the market, but none are as strong and of higher quality.  This rear end girdle was the first and is still the best.

Specifically designed to add support to the bearing caps under severe loads and acceleration, this girdle substantially strengthen the rear end. They also add fluid capacity, which helps to lower the fluid temperature. It has the engraved DTS logo. Comes with drain and fill plugs for easy maintenance.

• Made of 356 aircraft grade aluminum, heat treated to T6 specifications, each cover is then stress relieved.
• Incorporates a Fill Port and a Drain Port for ease of servicing.
• Incorporates 2 load bolts with swivel "feet" for supporting the bearing caps.
• Increases fluid capacity approx. 1/2 pint.
• Shows a decrease in operating temperature, average of 15 degrees.
• Weighs about 11 lbs.
• Improves Undercarriage Appearance.