These HiPoTek polyurethane conversion motor mounts will allow you to run the LA small block 318/340/360 in the 1997-2004 Dodge Dakota and 1998-2003 Dodge Durango RWD. You will also require the HiPoTek crank sensor adapter to retain the EFI (Electronic Fuel Injection) set-up for your vehicle: https://hi-potek.com/hipotek-crank-sensor-adapter-dodge-jeep-3-9-5-2-5-9-magnum-efi-mpi/

They are designed for street, street/strip, and strip applications.  It is a performance motor mount that is soft enough for the street, but stout enough for high horsepower racing applications at the track. Powder coated black. Plated inner sleeve. For rear wheel drive (RWD/2WD) vehicles.

Please note that on the driver’s side of the LA engine, you must measure the distance between the motor mount ears to be sure you get the correct driver’s side motor mount for your application. There was some variation through years. The spread of the driver’s side motor mount ears will either be 2 1/2” or 2 7/8”.   The photo above shows the measurement of the 2 1/2" spread, measured from the rear edge of each ear.

Made to order.  Approximately a 3 week lead time.